Computer to VX-5

Categories: Ham Radio, Technology
Comments: 2 Comments
Published on: May 24, 2005

I went to use my cable to connect my VX-5 to my computer, I wanted to do some programming of the memory channels, and found that cable had been severed so either I can program the whole radio by hand or I can spend the money and get a new cable, I am leaning to the second option. I will probably put it off till later, since it is not that important, I am talking much later.

2 Comments
  1. Tom says:

    Option 3: Solder a new plug on the end. Data (white wire) goes to the center strip of the plug and ground (black wire) goes to the ground tab.
    ’73s

  2. I might have to try that, thanks.

Welcome , today is Saturday, December 21, 2024